Real-PC diagnose boot (photo + OCR): the boot stick connects at
SuperSpeed on port 21 and 'device setup failed' lands in the SAME
millisecond — an instant failure, not a timeout. setupDevice reset
every port unconditionally; that is required to enable USB2 ports, but
a SuperSpeed port that trained its link is ALREADY enabled (xHCI
advances USB3 ports to Enabled, no reset — spec 4.3), and driving a hot
reset into the live link drops PED mid-reset on real silicon. QEMU
tolerates the spurious reset, which is why the harness never saw it.
An enabled speed>=4 port now skips the reset (a not-yet-enabled SS link
still gets one). Every setup step names its failure — port reset with
the PORTSC value, Enable Slot, device-slot exhaustion, Address Device
with its completion code — so the on-screen transcript of the next
failure identifies the exact xHCI command instead of one blanket line.
block.open's give-up window drops 60 s -> 30 s (the slowest observed
healthy chain completed at ~24 s); a machine whose stick failed setup
should not sit a further minute pretending otherwise.
Flesh out the xHCI host-controller driver into a full transfer engine and build
the three USB class drivers on top, all verified end to end under QEMU.
- xHCI engine (usb-xhci-library.zig): controller reset, command/event rings with
cycle-bit bookkeeping (gated on a No-Op-command proof), device slots, Address
Device, control transfers, full chapter-9 enumeration, Configure Endpoint, and
interrupt/bulk transfers. Each interface is device_registered with its
(class,subclass,protocol) identity, unique per (port,interface).
- Bus<->class transfer protocol (usb-transfer-protocol.zig + runtime.usb): open /
control / interrupt-subscribe (async report pump on a poll timer) / bulk-by-
physical-address, so sector data never crosses the 256-byte IPC limit.
- USB HID keyboard + mouse (usb-hid/): decode boot-protocol reports and publish
to the input service. A USB usage is already the input protocol's keycode.
- USB mass storage (usb-storage/): Bulk-Only Transport + transparent SCSI,
serving a block device under the new .block service id (block-protocol).
- device-manager matches USB interfaces to class drivers (usbDriverForIdentity).
- usb-abi / usb-ids made importable modules; add HID and mass-storage class
requests, packTriple, and a usb_device DeviceClass.
- Fix test/qemu_test.py on macOS: the QMP unix-socket path was built from the
deep worktree path and exceeded the 104-byte sun_path limit, so QEMU exited
before booting. It now lives under a short temp path.
Tests: usb-report, usb-hid, usb-storage pass under python3 test/qemu_test.py;
host units (usb-abi, usb-ids, hid-report, bulk-only-transport, scsi) green.
Daniel Samson